DEEPCOOL MATREXX 55 MESH ADD-RGB 4F Review

Many times it is not possible to meet your needs due to lack of time and review unit.  So from now on there will be instant reviews with different types of products.  Where product details may not be available, efforts will be made to provide as much information as possible.  So let's get started.

 DEEPCOOL

 MATREXX 55 MESH ADD-RGB 4F

Introduction:

DEEPCOOL was established in 1996 with its headquarters in Beijing and factory in Shen Zhen.  As the name suggests, it is a cooler manufacturer, but they don't just make coolers, they also make a number of PC related products.

Model:

Initially you can understand this from the name. It has 4 ARGB fans with MESH on the front and top and EATX motherboard can also be installed in it.

This is a mid tower case where ABS Plastic, SPCC steel and Tempered Glass have been used as the building materials of the case.  Dark gray colour which looks very good.  The total weight is about 6.6 kg.

Product Dimensions - 440X210X480mm

Power and Reset Button, I / O Ports are provided as 2 USB 2.0, 1 USB 3.0, 1 Headphone and 1 Mic in report, DEEPCOOL logo at the very bottom.

The front has a steel mesh covering almost the entire part with 3 120mm ARGB fans on the back.  120/140/240/280 / 360mm radiator can be fitted for liquid cooling.

The side uses 4mm Thick Tempered Glass which is applied using rubber washer through hole hole screw method, the glass can be called quite dark.

The back panel is also made with Steel.

There are 2 120 / 140mm fans or 120/140/240 / 280mm radiators can be installed on the top.  The top has a magnetic dust filter that can be easily removed and cleaned if needed.

The back can be fitted with a 120mm fan and radiator as needed.

At the bottom of the inside is the PSU Shroud which will cover the power supply and its cables. There are small cut outs to view the PSU, but care must be taken so that the PSU is not larger than 170mm.  PSU can easily take in air as there is air vent below.  Shroud has 2 3.5 ”HDD cases on the back, and 2 2.5” sata SSDs on the motherboard tray.

ITX / Micro-ATX / ATX / E-ATX Motherboard can also be installed as there is a lot of space inside.

There are 12 cut outs for cable management and some punch holes for holding.

CPU Cooler Clearance Max 168mm and GPU Clearance Max 370mm.

Since the main goal of the case is to use a lot of air flow and RGB fan, they have provided several cables.

4pin Fan splitter

ARGB daisy chain cable

2 types of 5v argb cable and many fan screw to sync with motherboard

In the end, it is safe to say that the case did not go unnoticed.

However, at this price, the build quality is a little better.

Cable management cut out did not provide any type of rubber grommet which should have been provided,

An ARGB Controller should have been provided,

Tempered Glass mounting process needs to be improved.

Until today, I will appear before you again in the future with something.  Looking forward to your feedback in the comment box.